Restore & Protect Your Asphalt
Seal coating is the single best thing you can do for your asphalt driveway. It creates a protective barrier against UV rays, water, oil, and Kansas City's brutal freeze-thaw cycles — all while restoring that fresh, dark finish.
We use commercial-grade sealant (the same products used on highways) applied with proper prep and cure time. No shortcuts.
What We Protect Against
- UV damage — sun oxidizes the binder, turning your driveway gray and brittle
- Water intrusion — moisture seeps into pores and cracks, then freezes and expands
- Freeze-thaw cycles — KC winters swing above and below freezing dozens of times per season
- Oil & chemical spills — vehicle fluids eat away at the asphalt binder
- General wear — daily traffic grinds down the surface layer over time
Our Process
Surface Prep
Clear debris, dirt, and vegetation. Treat oil spots with primer so sealant bonds properly.
Crack Filling
Fill cracks with professional-grade rubberized filler before sealing for a smooth, uniform result.
Sealant Application
Two coats of commercial-grade sealant applied with professional spray equipment or squeegee.
Cure & Handoff
Walk you through cure times (24-48 hrs). We schedule around the weather forecast.
Signs It's Time to Seal Coat
Most asphalt driveways should be sealed every 2-3 years. Not sure if yours is due? Look for these:
- Driveway has faded from black to gray
- Small cracks forming, especially along edges
- Surface feels rough or gritty instead of smooth
- Water no longer beads on the surface
- It's been 3+ years since the last seal coat
Best time to seal coat in KC: April through October, when temps stay above 50°F. New asphalt? Wait 6-12 months before the first coat.